Guide to Fabricating FlexClad

Directions for use:

Surfaces must be clean, dry and free from dust, dirt, frost, grease and other contamination.

It is suggested that the oversize holes or slots are staggered at maximum 500mm centres, 45mm from the face and 35mm from the back of the profile for NovaFlex boxes (other systems should be adjusted accordingly).

Cut the cartridge tip and applicator nozzle to 5-6mm, and apply; where possible the adhesive should be applied to the powder coated surface first.

Temperature application range between +5°c and +40°c.

It is always the user’s responsibility to determine suitability of use. If in any doubt, consult technical data sheet.

*The above has been issued purely as a guideline, and can differ for each individual project *

Back to FlexClad