Guide to Fabricating NovaDisplay
Single Sided Box
Slide fabric grip into the front seating channels before cutting
Cut to size by mitring profile to length and height of box required
Cut supports 14mm less than the height of box
Assemble both ends to the bottom section using cleats provided and tighten
Supports positioned 150mm from each end and up to 600mm centres thereafter – rivet in place
Place top section in position at both ends using cleats and ensure supports are located in seating channel, assemble using cleats and tighten
Lay box face down and ensure ends and all supports are square before securing into position.
Backing sheet 0.6 – 0.9mm thick to be cut 30mm less than the height of the box
**maximum size for box 6000 x 2000mm**
Double Sided Box / Frames
Slide fabric grip into the front seating channels before cutting
Cut to size by mitring profile to length and height of box required
Assemble using corner cleats provided and tighten
**maximum size for double sided box when illuminating is 1000mm high**
*The above has been issued purely as a guideline, and can differ for each individual project *
- Home
- Signage
- NovaDisplay
- Guide to Fabricating NovaDisplay