Guide to Fabricating Pole & Plank
- Posts and infill should be cut to the required length
- To achieve the panel / plank size refer to the guide below
- Units up to 1000mm in height should be planted into the ground by a minimum of 600mm and by at least a third of the overall height thereafter
- For all units 3000mm high, the 60 x 40mm steel insert should be used
- Panels fabricated using the panel plank and bracing bar should be constructed from a 2mm rigid material with panel plank top and bottom and the bracing bar at both ends and 600mm centres thereafter
Quick Reference Guide
To achieve cutting sizes for panels / planks:When using round posts + 14mmWhen using square posts + 18mmWhen using D posts + 14mmWhen using Wall posts + 14mm
Infill cut at post height minus panel height
V Carrier / Composite Carrier cut at panel height
*The above has been issued purely as a guideline, and can differ for each individual project *
- Home
- Signage
- Pole & Plank
- Guide to Fabricating Pole & Plank