NovaFlex Skin Preparation
Vinyl Face Preparation
Cut vinyl 230mm more than overall size of box.Fold approximately 76mm to form a loop 38mm
Note: Vinyl should be stitched or welded to form a loop on all four sides of the face
To Fit The SkinThread rods into the pockets on the long lengths first and then slide puller bar over ensuring teeth are facing towards rear of the skin (N.B corner rod and pullers should be set approx. 50mm from end). Roll up skin, loosen top and bottom pullers and set equally. Hook on top and then unroll and hook on bottom. Thread rod and puller in end pockets and hook on. Then follow tensioning procedure as below Tensioning Face ProcedureTake up slack at both ends of the face and tension the face diagonally (i.e – A-A / B-B as shown below)DO NOT OVER TIGHTEN THE ENDS AS IT MAY CAUSE DISTORTIONIdeally tensioning is a two-person procedure
NovaFlex Skin Material
Material Recommended for NovaFlex:
VuFlex Backlit Premium FR
| Roll Width | 1600mm / 3200mm / 5000mm |
| Roll Length | 30m |
| Base Fabric | PES DIN ISO 2076 |
| Yarn | 110d/tex |
| Weave | 1/1L |
| Type of Coating | PVC |
| Weight | 500 g/m2 |
| Tensile Strength | 2700/2700 (WARP/WEFT) |
| Tear Strength | 280/280 (WARP/WEFT) |
| Adhesion | 18 N/cm |
| Cold Resistance | -30°c |
| Heat Resistance | +70°c |
| Light Fastness | to DIN 54004 |
| Crack Resistance | to DIN 53359 A |
| Flame Retardency | to DIN 4102 B1 M2 |
| Finish | Both sides acrylic lacquered |
This product has been produced for digital inkjet printing, but customers must satisfy themselves that the product will perform to their requirements by testing prior to production run taking place.Specification details are offered in good faith but will not be accepted in matters of warranty
Skin SpecificationCut size = + 265mmBleed size = +100mmVisual Size = (full bleed so same as box size)